Figure 4-45.3. Transmission Mounting.

TM55-1730-228-13&P

4-33. ENGINE - REPLACE (Continued)

4-33

NOTE

Be sure spider between engine and transmission draft coupling is in position.

(3) Position transmission and mount (19) on adapter plate (20), align drive adapters and secure with four

capscrews (17) and lockwashers (18).

(4) Remove slings and hoist from transmission.

(5) Place hoist of suitable lifting capacity over engine (11). Install slings.

(6) Place rope starter guard (25) on frame.

(7) Carefully lower engine/transmission assembly on engine rack mounting brackets (16).

Figure 4-45.3. Transmission Mounting.

(8) Secure engine (11) to mounting brackets (16) with three capscrews (12), washers (14) and nuts (13).

(9) Remove slings and hoist.

(10) Connect two transmission control solenoid connections (7 and 8, Figure 445.3) using the tags for

identification. Secure connections with screws.

(11) Remove plugs from transmission ports. Connect seven hydraulic hoses to transmission using the tags for

identification.

(12) Install u-bolt (6) around transmission (4) and into bracket (9).

(13) Secure u-bolt (6) with two nuts (5).

(14) Carefully position hydraulic pump/manifold block assembly (3) on end of transmission (4). Be sure drive

shaft of hydraulic pump is fully engaged with transmission.

(15) Secure hydraulic pump/manifold block assembly (3) with two capscrews (1) and washers (2).

GO ON TO NEXT PAGE

4-119