REMOVAL - TM-55-1730-228-13-P0275

TM 55-1730-228-13&P

4-24. STEERING ASSEMBLY - REPLACE (Continued)

4-24

a. REMOVAL:

(1) Support stabilizer (1, Figure 4-27) with a suitable hoist and sling assembly.

(2) Remove retaining ring (2), and washer (3).

(3) Drive retaining pin (4) toward opposite retaining ring. Remove pin with retaining ring (5) and washer (6).

(4) Remove stabilizer (1) from frame member (7) with hoist and sling assembly.

(5) Remove nut (8) and pad assembly.

(6) Remove four capscrews (9) and washers (10) securing stud cover (11) to pad (12).

(7) Remove stud (13) and cover (11).

b. INSTALLATION:

(1) Slide stud cover (11) over stud (13) and position in pad (12).

(2) Secure stud cover (11) with four capscrews (9) and washers (10). Tighten screws securely.

(3) Slide pad assembly through stabilizer and secure with nut (8).

(4) With stabilizer (1) supported with a suitable hoist, and sling assembly, align holes of frame member (7) and

stabilizer.

(5) Install retaining pin (4) with washer (6) and retaining ring (5) through stabilizer (1) and frame (7).

(6) Install washer (3) and retaining ring (2).

(7) Remove hoist and sling assembly.

(8) Install the stabilizer cylinder (see para 3-36).

(9) Lubricate stud ball (12) with a light film of GAA grease.

END OF TASK

4-83