INSTALLATION - TM-55-1730-228-13-P0166

TM55-1730-228-13&P

3-37. STEERING CYLINDER - REPLACE (Continued)

3-37

(6) Remove the set screw (6) from collar securing the rod eye.

(7) Remove the rear tie rod link pin (7).

NOTE

You may have to raise the front of the frame and turn the wheels to gain access to the rod eye pin.

(8) Remove the spacer sets (8 and 9) from each end of the cylinder (3). Tag spacers.

(9) Remove the cylinder (3).

(10) Repair tag the cylinder and return to tech supply.

b. INSTALLATION:

(1) Clean eye pin (5) and link pin (7) in cleaning solvent and lubricate with a light film of GAA grease.

(2) Position the cylinder within the steering assembly. The cylinder eye is secured to the eye weldment (10)

on the right side of the pivoting axle; the rod eye is secured to the center of the tie bar assembly and the

cylinder ports face towards the rear.

(3) Align the cylinder eye with the eye weldment. Install the spacers (9).

(4) Install the cylinder eye pin (5) from the top.

(5) Secure the pin with pin clip (4).

(6) Align the rod eye (11) and tie rod link with the center hole in the tie bar assembly.

NOTE

Move the rod in or out as needed to align the rod eye.

(7) Install the spacer set (8) and collar.

(8) Install the rear tie rod link pin (7) with the hole offset towards the bottom.

(9) Install set screw (6) in collar and tighten.

GO ON TO NEXT PAGE

3-97