PREPARATION FOR MOVEMENT

TM55-1730-228-13&P

(4) Backing SPEMS Away From Work Area (Forward Position):

(a) Remove tools and materials from deck extensions.

(b) Detach static discharge lines.

(d) Start SPEMS and allow to idle for 15 minutes to warm up.

(e) Traverse deck back.

(f) Raise stabilizers.

WARNING

Tools and obstructions on or around SPEMS could injure personnel and/or damage equipment. Make sure

area behind SPEMS is clear or personnel and obstructions.

(g) Back SPEMS approximately 10 feet (3 meters) away from aircraft.

(h) Attach top section of guardrails on deck extensions.

(i) Lower platform.

2-14. PREPARATION FOR MOVEMENT

2-14

a. Towing.

WARNING

Improper towing of the SPEMS can result in conditions which may be hazardous to personnel. To prevent

hazards to personnel and equipment, the following towing procedures must be followed.

CAUTION

If the SPEMS is towed improperly, extensive damage can result.

WARNING

Never use a lift (fork) truck to position the SPEMS. Extensive damage can result.

GO ON TO NEXT PAGE

2-34