 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 55-1730-227-13&P
3-64.
Parking brake assembly - Replace (Cont)
3-64
REMOVAL (Cont)
END OF TASK
INSTALLATION
1. Position the brake assembly on the rear axle and aline holes.
2. Install four hex head cap screws through the brake assembly and place a lock
washer and a plain hex nut on each screw. Tighten nuts to a torque of 19 ft-lbs.
3. Position the brake drum and hub assembly on brake assembly after installing
hub and bearings (Refer to paragraph 3-61).
NOTE
Brake assembly is self adjusting.
END OF TASK
3-97
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals