REASSEMBLY - TM-55-1730-227-13-P0060

TM 55-1730-227-13&P

3-25.

Pallet assembly - Replace (Cont)

3-25

DISASSEMBLY (Cont)

2. Remove eight hex head cap screws with self-locking nuts securing the four tie-

down mounts, located on the front and rear pallet cross-members. Remove tiedown

mounts.

3. Remove six countersunk socket screws, self-locking nuts and flat washers se-

curing each top corner plate to the pallet assembly. Remove four top corner plates.

4. Turn the pallet assembly over and remove four hex head cap screws with self-

locking nuts and flat washers, securing each bottom corner plate. Remove the four

bottom corner plates and separate the front, rear, left side, and right side pallet

members from each other.

END OF TASK

REASSEMBLY

1. Place the front and rear pallet members on a clean, level surface, with the open

channeled sides facing each other. There should be eight holes showing on top of

each pallet end.

2. Position the left and right side pallet members across from each other with the

channeled sides facing away from each other. There should be four holes showing

on top of each left and right side pallet end.

3. Position four bottom corner plates under the pallet ends and sides. Aline the

holes and install four hex head cap screws, flat washers and self-locking nuts into

each corner plate. Tighten nuts to a torque of 276 in-lbs.

4. Place two top corner plates with slotted holes in opposite corners of each other.

Place two corner plates without slotted holes in the remaining corners. Install six

countersunk socket screws, flat washers and self-locking nuts into each top corner

plate. Tighten nuts to a torque of 276 in-lbs.

5. Install four tiedown mounts on the front and rear pallet members with eight hex

head cap screws and self-locking nuts. Tighten nuts to a torque of 228 in-lbs.

6. Position the clearance indicating reflectors as noted in paragraph 3-25, step 1,

of the disassembly procedures and install sixteen roundhead machine screws with

hex nuts. Tighten nuts to a torque of 72 in-lbs.

END OF TASK

3-32