|
|
![]() TM 55-1670-259-20
APPENDIX C
REPAIR PARTS AND SPECIAL TOOLS LISTS
(Current as of 25 June 1970)
Section l. INTRODUCTION
C-1. SCOPE.
cured or stocked. The requirement for
such items will be filled by use of the
This appendix lists the repair parts required for the
performance of organizational maintenance of the
next higher assembly or component.
X2
Miscellaneous External Air Transport Items.
Applies to repair parts which are not
stocked. T h e indicated maintenance
category requiring such repair parts will
C-2. GENERAL.
attempt to obtain same through canni-
This Repair Parts and Special Tools Listing is
balization. Where such repair parts are
divided into the following sections:
not obtainable through cannibalization,
a. Prescribed Load Allowance (PLA) - Section II.
requirements will be requisitioned, with
A composite listing of the repair parts and special
accompanying
through
t o o l s having quantitative a l l o w a n c e s for initial
normal supply channels.
stockage at the organizational level.
(2) Maintenance code. Indicates the lowest cate-
b. Repair Parts - Section III. A list of repair parts
gory of maintenance authorized to install the listed
item. The maintenance level code is:
authorized for the performance e of maintenance at the
organizational level.
CODE
EXPLANATION
c. Special Tools - Section IV. A list of special
O
Organizational maintenance
tools authorized for the performance of maintenance
at the organizational level.
(3) Recoverability code. Indicates whether un-
serviceable items should be returned for recovery or
salvage. Items not coded are expendable. Recover-
d. Federal Stock Number and Reference Number
ability code is:
Index - Section V. A list of Federal stock numbers in
ascending numerical sequence followed by a list of
EXPLANATION
CODE
reference numbers in ascending alpha-numerical se-
Applies to repair parts and assemblies
quence, cross-referenced to group number.
R
w h i c h are economically reparable at
DSU and GSU activities and are normally
C-3. EXPLANATION OF COLUMNS.
furnished by supply on an exchange
The following provides an explanation of columns in
basis.
the tabular lists in Sections II, III, and IV:
b. Federal Stock Number. Indicates the Federal
a. Source, Maintenance, and Recoverability Codes:
stock number assigned to the item and will be used
(1) Source code. Indicates the selection status
for requisitioning purposes,
and source for the listed item. Source codes are:
c. Description. Indicates the Federal item name and
CODE
EXPLANATION
any additional description of the item required. The
P
description column contains the following subcolumns.
Applies to repair parts which are stocked
in or supplied from GSA/DSA, or Army
(1) Reference number and manufacturer's code.
supply systems and authorized for use
Indicates a part number or other reference number for
at indicated maintenance categories.
the listed item followed by the applicable five-digit
Applies to repair parts which are not pro-
M
Federal supply code for manufacturers in parentheses.
cured or stocked, but are to be manu-
factured in indicated
maintenance
levels.
(2) Usable on code. Indicates an alpha coding to
Xl
reflect the application of the listed item to the
Applies to repair parts which are not pro-
Change 1
C-1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |