Click here to make tpub.com your Home Page

Page Title: CLOSING WSC
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 9-8140-381-14&P
1-7.
CLOSING WSC
f. Pull knob on lock bolt forcefully to the left to
insure bolt is securely locked into position.
a. Remove the two pads and store them in a
convenient location on the pallet base'
1-9.
HANDLING/TIEDOWN OF WSC
b. Ensure deck plate sliders are in fully engaged
Handling and lifting can be accomplished by a forklift
position so they do not interfere with locking
certified to lift the total weight of the WSC.
tangs.
NOTE
WARNING
The external tiedown rings (8 top, 4
TWO PERSONS MUST SUPPORT
bottom) are not to be used for lifting
THE WSC COVER AFTER THE TWO
WSC.
QUICK
RELEASE
PINS
ARE
REMOVED UNTIL THE COVER IS
LOWERED.
1-10.
INSPECTION
1-10.1.  This section outlines inspection procedures
NOTE
required for the WSC. An initial receipt inspection is not
The two flat hooks at front of deck
included. Inspection procedures are to be performed on
plate must be facing inward to
a semi-annual basis beginning when the empty WSC is
ensure proper closing.
first received in accordance with table 1-1.
1-10.2. Maintenance required as a result of inspection
c. Using two persons to support the WSC cover,
is shown in table 1-1 and shall be performed in
remove the two quick release pins. Store the
accordance with chapter 2.
quick release pins in the receptacles on the
safety brackets (struts).
1-10.3.  Items or components will not be rejected when
inspection criteria are applied as long as item (or
component) is still serviceable; that is, the item will not
d. Pull the hinge section of the safety brackets
impair normal loading or unloading contents operations,
(struts) forward while slowly lowering the cover.
violate a safety requirement, or damage any other
component as a result of its use. Specific defects which
1-8.
LOCKING WSC
are not cause for rejection are: (1) dents or small holes
in the steel mesh, (2) caster wheels which are chipped,
a. Apply a downward force on front of cage cover
flaked, gouged, or have pieces missing which do not
and engage catches with the strike; secure by
impair rolling of the wheel, or (3) scratches or gouges in
moving catch handle down and towards strike
paint on fork lift tubes, pallet base, or tiedown rings.
until they snap into position.
Paint scratches or gouges exposing base metal in areas
other than those listed in (3) above, shall be touched up
b. After catches are secured, push each lock bolt
as deemed necessary.  Where judgement is required
to the right until bolt is seated in housing.
during an inspection, the person performing the
inspection will make the judgment.
c. Rotate protective cover to expose code wheels.
1-10.4.
Visual inspections shall be accomplished
without the aid of magnification.
d. Rotate each code wheel on locking device until
diamond figures are alined between indexing
1-10.5. Removal of foreign materials (mud, salt, water,
marks.
grease, oil, fungus, etc) and corrosion shall be
accomplished in accordance with appendix C.
e. Return protective cover to its original position.
1-7

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business