Section I. INTRODUCTION - TM-9-6695-263-34P0002

TM 9-6695-263-34P

Section I. INTRODUCTION

1. Scope. This manual lists spares and repair parts

b. Source,

Maintena nce,

and

Recoverability

that are required for maintenance of Analyzer,

(SMR) Codes.

Modulation, Hewlett-Packard Model 8901A.

authorizes the requisitioning and issue of spares and

(1) Source Code. Source codes indicate the

repair parts as indicated by the source and maintenance

manner of acquiring support items for maintenance,

codes.

repair, or overhaul of end items. Source codes are

entered in the first and second positions of the uniform

2. General. This repair parts and special tools list

SMR code format as follows:

(RPSTL) is divided into the following sections:

Code

Definition

a. Section II. Repair Parts List. A list of spares

and repair parts authorized for use in the performance of

PA -

Item procured and stocked for anticipated or

maintenance. Parts are listed in alphabetical sequence

known usage.

within each figure number.

(2) Maintenance Code. Maintenance codes

b. Section III. Special Tools List. Not applicable.

are assigned to indicate the levels of maintenance

authorized to USE and REPAIR support items. The

c. Section IV. National Stock Number and Part

maintenance codes are entered in the third and fourth

Number Index. A list, in National item identification

positions of the uniform SMR code format as follows:

number (NIIN) sequence, of all National stock numbers

(NSN's) appearing in the listings, followed by a list in

(a) The maintenance code entered in

alphanumeric sequence of all part numbers appearing in

the third position will indicate the lowest maintenance

the listings.

NSN's and part numbers are cross-

level authorized to remove, replace, and use the support

referenced to the figure and item number appearance.

item. This position will contain the following code:

Explanation of Columns.

Code

Application/Explanation

a. Illustration. This column is divided as follows:

F-

Support item is removed, replaced, and used at

the direct support level.

(1) Figure Number.

Indicates the figure

number of the item shown.

(b) The maintenance code entered in

the fourth position indicates whether the item is to be

(2) Item Number.

The number used to

repaired and identifies the lowest maintenance level with

identify each item called out in the list.

the capability to perform complete repair (i.e., all

authorized maintenance functions).