Special Information - TM-9-6695-245-34P0006

TM 9-6695-245-34P

h. Quantity Incorporated in Unit. Indicates the quantity of the item used in the breakout shown on the illustration

figure, which is prepared for a functional group, subfunctional group, or an assembly. A "V" appearing in this column in lieu

of quantity indicates that no specific quantity is applicable (e.g., shims, spacers, etc).

4. Special Information

a. Repair parts for components of standards sets which can be identified as existing in the supply system will be

requisitioned through normal supply channels from the appropriate supply commodity manager.

b. Repair parts for components of standards sets which cannot be identified as to proper supply source will be

requisitioned from USAMICOM, using routing identifier B64 and furnishing as a minimum, the following as exception data.

(1) Component stock number of the individual end item to be repaired.

(2) Component manufacturer's equipment model number and serial number.

(3) The equipment manufacturer's stock number as listed in the appropriate manual for the desired repair part.

(4) The repair part reference, designation, circuit reference, circuit symbol schematic designation, or reference

number as listed in the manufacturer's manual.

(5) The technical specification of the repair part as contained in the appropriate manufacturer's manual.

(6) The title and date of the manufacturer's manual from which the information in paragraphs a, b(3), (4), and (5)

above was taken.

NOTE

Repair parts should not be requisitioned for plug-in boards identified in the plug-in board exchange program, except by the

depot designated to perform the repair. Repair of calibration set components, with plug-in board assemblies or

subassemblies designated as program exchange replacements with a recoverability code of L, will be accomplished by

replacing the plug-in board.

The plug-in board exchange program functions are as follows:

(1) Requisitioning instructions for initial issue plug-in boards will be provided since new instrument boards

are included in the program.

(2) As a plug-in board covered by the program fails, a replacement will be requisitioned. Requisitions will be submitted

to Commander, US Army Missile Command, B64, Redstone Arsenal, AL 35809.

(3) Simultaneously with c(2) above, the defective board being replaced will be shipped by certified mail, return receipt

requested, to the following address:

Transportation Officer

Anniston Army Depot

M/F Field Service Stock

Anniston, AL 36201

When requisitioning a replacement board, the turn-in document number of the replaced board shall be cited on the

requisition.

5. How to Locate Repair Parts

a. When NSN or reference number is unknown:

(1) First. Using the table of contents, determine the assembly (functional group) within the repair part belongs.