Special Information - TM-9-6625-1990-34P0006

TM 9-6625-1990-34P

h. Quantity Incorporated in Unit. Indicates the

NOTE

quantity of the item used in the breakout shown on the

illustration figure, which is prepared for a functional

Repair

parts

should

not

group, subfunctional group, or an assembly. A "V"

requisitioned for plug-in boards

appearing in this column in lieu of quantity indicates that

identified in the plug-in board

no specific quantity is applicable (e.g., shims, spacers,

exchange program, except by the

etc).

depot designated to perform the

repair.

Repair of calibration set

4. Special Information

components, with plug-in board

assemblies

subassemblies

a. Repair parts for components of standards sets

designated as program exchange

which can be identified as existing in the supply system

replacements with a recoverability

will be requisitioned through normal supply channels

code of L, will be accomplished by

from the appropriate supply commodity manager.

replacing the plug-in board.

b. Repair parts for components of standards sets

c. The plug-in board exchange program functions

which cannot be identified as to proper supply source

are as follows:

will be requisitioned from USAMICOM, using routing

identifier B64 and furnishing as a minimum, the following

(1) Requisitioning instructions for initial issue

as exception data.

plug-in boards will be provided since new instrument

boards are included in the program.

(1) Component stock number of the individual

end item to be repaired.

(2) As a plug-in board covered by the

program fails, a replacement will be requisitioned.

(2) Component manufacturer's

equipment

Requisitions will be submitted to Commander, US Army

model number and serial number.

Missile Command, B64, Redstone Arsenal, AL 35809.

(3) The equipment manufacturer's stock

(3) Simultaneously with c(2) above, the

number as listed in the appropriate manual for the

defective board being replaced will be shipped by

desired repair part.

certified mail, return receipt requested, to the following

address:

(4) The repair part reference designation,

circuit reference, circuit symbol schematic designation,

Transportation Officer

or reference number as listed in the manufacturer's

Anniston Army Depot

manual.

M/F Field Service Stock

Anniston, AL 36201

(5) The technical specification of the repair

part as contained in the appropriate manufacturer's

When requisitioning a replacement board, the turn-in

manual.

document number of the replaced board shall be cited

on the requisition.

(6) The title and date of the manufacturer's

manual from which the information in paragraphs a, b(3),

5. How to Locate Repair Parts

(4), and (5) above was taken.

a. When NSN or reference number is unknown:

(1) First.

Using the table of contents,

determine the assembly (functional group) within which

the repair part belongs.