CARBIDE BRAKE DRUM TOOLS

TM 94940462-14&P

NOS. RB-6 & LB-6

Solid tools with large, high quality carbide tip. Sandwich

brazing gives better heat dissipation and longer cutting life.

Painted to prevent rust. Packaged 2 per plastic box to pro-

vide one for spare.

NOS. A-6, R-6 & L-6

CARBIDE BRAKE DRUM TOOLS

With 3 replaceable carbide tips. Each tip has 6 factory

ground cutting edges. When one edge gets dull, loosen screw

and reset tip to new edge. Quick, convenient, less cost than

resharpening.

NO. T-8 REPLACEABLE CARBIDE TIPS, set of 3 (18 cutting

edges) for above.

NO. 600

BRAKE HUB & DRUM FIXTURE

Removes old studs, swages shoulders on new studs, heads

and sets rivets, including pilot rivets. Efficient one-man opera -

tion. Spring-loaded fingers keep toolholder up while drum is

rotated. Used with heavy duty press like No. PH-25F.

NO. FBP

GENERATOR BEARING PULLER

Removes generator bearings without damage. Held in vise

when used. Supplied with one slotted washer (%" opening)

for Ford. No. FBP-W slotted washer (3/4" opening) optIon-

al for GM.

NO. UJ-1

UNIVERSAL JOINT FIXTURE

For bearings on cross and yoke type U-joints. Hand tightened

to hold in position, then pressed in vise with 5" opening. Not

a C clamp. A third hand when working on U-joints.

TAILSTOCK REST

NO. TR

An accurate self-centering tailstock rest for use in general

purpose engine lathes. Unusually large capacity, 1/4" to 1".

Specify #1, 2, or 3 Morse Taper Arbor.

MICA UNDERCUTTER

NO. 30

Adjusts for variations in shaft lengths and diameters, also for

length and depth of undercutting. Convenient direct motor

drive. No. 30-C Centers available but not included. Handles

armatures up to 7" core diameter and 13" between V-rests;

commutators up to 6" diameter and 3 1/2" length. Motor is

115V 60C.

NO. 40-1

MICA UNDERCUTTER ATTACHMENT

For general purpose engine lathes. Easily attaches to lathe

in place of tool post. Handles commutators up to 6" diameter.

Other specifications depend upon lathe being used. 115V

60C motor. When order-

ing, you must state di-

mensions A and B on com-

pound rest to get proper

size slot nut for your

lathe.

All products are guaranteed, without excep-

tion, against defective material or work-

manship. We reserve the right to discontinue

or to change any product without notice.