HYDRAULIC PRESSES - FLOOR & BENCH

TM 9-4940462-14&P UTILITY PRESS & ATTACHMENTS NO. MP-1

Versatile, inexpensive bench press. Easily bandies difficult

small jobs. Manual operation gives more sensitive control.

Keeps larger press free, Extends beyond bench open on

bottom and sides. Uses bed with flat or V-rest.

NO. MP-1 MANUAL UTILITY PRESS complete, includes both

MP-1P and MP-1A as illustrated, and as listed below,

NO. MP-1P PRESS only, includes frame, screw, bed plates,

and mounting rods as shown.

NO. MP-1A ATTACHMENTS only, includes support plate to

hold pole shoe against case, plus screwdriver unit with 1

straight bit 3/32" wide and 2 square bits 7/32" and 9/32", as shown.

No. PB-3 Phillips Bit (#3 size) and No. PB-4 Phillips Bit (#4

size) are also available.

HYDRAULIC PRESSES . . .

FLOOR & BENCH - 10 & 25 TONS

Save time and effort. Save damage to costly parts. Limitless

uses and opportunities for new profits. Hydraulic unit is mov-

able between uprights. Sides are open.

PRESS APPLICATIONS ILLUSTRATED

1. PH-1F press used with puller plates and PH-9 fixture to

remove axle bearings. PH-25F press is preferable because

extra power permits more jobs and puts less strain on the

hydraulic unit.

2. PH-1B press with PH-3 puller bars to remove pulleys. Press

mounted between two benches, or with opening in bench,

permits PH-3 bars to hang from base of press frame for extra

length.

3. PH-1B (or PH-1F) press with PH-2 screwdriver, PH-4 pole

shoe expander, and PH-8 V-rest to remove or insert pole shoe

screws.

HYDRAULIC PRESS ATTACHMENTS

(not included with presses)

*PH-2 POLE SHOE SCREWDRIVER, includes 1 straight bit 312"

wide and 2 square bits 7/32" & 9/32". Also see Nos. PB-3 and

PB-4 optional Phillips Bits.

*PH-3 HANGING PULLER BARS, one pair

PH-4 POLE SHOE EXPANDER, for cases with inner diameter

2 3/4" to 3 3/4"

PH-4A EXTRA EXTENSION PLATES, one pair, each pair in-

creases maximum diameter of PH-4 by 3/8".

PH-6 V-BLOCKS, one pair

PH-8 V-REST

PH-9 AXLE BEARING FIXTURE

* For use with 10 ton (PH-1F and PH-1B) presses only.