OPERATOR'S ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS LIST

TM 9-4940-411-14&P

TECHNICAL MANUAL

HEADQUARTERS

DEPARTMENT OF THE ARMY

No. 9-4940-411-14&P

WASHINGTON DC, 9 May 1980

OPERATOR'S ORGANIZATIONAL, DIRECT SUPPORT

AND GENERAL SUPPORT MAINTENANCE

MANUAL INCLUDING REPAIR PARTS LIST

FOR

TANK, PRESSURE

MODEL ASME-A3

(PAASCHE AIR BRUSH CO.)

(NSN 4940-00-251-6478)

REPORTING OF ERRORS

You can improve this manual by recommending improvements using, DA Form

2028 (Recommended Changes to Publications and Blank Forms) or DA Form

2028-2 located in the back of this manual. Mail your form direct to Commander,

US Army Armament Materiel Readiness Command, ATTN: DRSAR-MAS, Rock

Island, IL 61299. A reply will be furnished direct to you.

NOTE

This manual is published for the purpose of identifying an authorized commercial manual for the use of the personnel to

whom the tank is issued.

Manufactured by: Paasche Airbrush Company

1909 W. Diversey Parkway

Chicago, IL 60614

Procured under Contract No. DAAA09-75-M-8505

This technical manual is an authentication of the manufacturers' commercial

literature and does not conform with the format and content specified in AR 310-3,

Military Publications. This technical manual does, however, contain available

information that is essential to the operation and maintenance of the equipment.

INSTRUCTIONS FOR REQUISITIONING PARTS

NOT IDENTIFIED BY NSN

When requisitioning parts not identified by National Stock Number, it is mandatory that the following information be

furnished the supply officer.

1- Manufacturer's Federal Supply Code Number -

2- Manufacturer's Part Number exactly as listed herein.

3- Nomenclature exactly as listed herein, including dimensions, if necessary.

4- Manufacturer's Model Number-

5- Manufacturer's Serial Number (End Item)

6- Any other information such as Type, Frame Number, and Electrical Characteristics, if applicable.

7- If DD Form 1348 is used, fill in all blocks except 4, 5, 6, and Remarks field in accordance with AR 725-50.

Complete Form as Follows:

(a) In blocks 4, 5, 6, list manufacturer's Federal Supply Code Number followed by a colon and manufacturer's Part

Number for the repair part.

(b) Complete Remarks field as follows:

Noun: (nomenclature of repair part)