Connect W10 Cable

TM 9-4931-381-14&P-1

FRAME 14

Connect W10 Cable:

CAUTION

Make sure connector (1) is unplugged from 115 V ac source

and power supply (2) is set to OFF before connecting W 10

cable (3) to TSTS (4) to prevent damage to the TSTS (4).

NOTE

Frames 14 and 15 are for preparation for operation as part

of a troubleshooting procedure.

Make sure TEST SET POWER switch (5) is set to OFF. Make sure circuit breaker

CB1 (6) is closed.

Connect W10 cable connector P1 (7) to test set connector J13 PWR IN (8).

Plug connector (1) into 115 V ac source. Plug power supply (2) into 115 V ac source.

Set power supply ON/OFF switch (9) to ON. Set power supply voltage to 28 1 V dc

and power supply current to maximum.

Make sure THERMAL MO DE switch (10) and THERMAL TEST switch (11) are set

to OFF.

Set TEST SET POWER sw itch (5) to ON. Automatic self-test will now run. Wait

15 seconds.

GO TO FRAME 15

Volume I

4-26

Change 1

Para. 4-17