Coil Voltage Test (Delco-Remy 1115282).

TM 9-4910-736-14&P

(1) Connect TEST LEAD with red boot to + terminal and the other TEST

LEAD to - terminal.

(2) Depending upon the coil under test, using the proper adapter (as

indicated below), connect the COIL PICK-UT to the high tension tower

of the coil.

Coil under test

Adapter no.

Prestolite - Autolite 115047

403BA032

P&D Mfg. VC2X

403BA032

Delco-Remy 1915992

403BA031

(3) Connect black lead attached to COIL PICK-UP to chassis of vehicle

or to another good ground.

(4)

Set FUNCTION switch to COIL.

WARNING

When PUSH TO TEST switch is depressed, HIGH VOLTAGE is

present across all leads and coil under test. DO NOT

touch leads or coil under test when PUSH TO TEST switch

is depressed.

(5) Observe WARNING and depress PUSH TO TEST switch. While holding

PUSH TO TEST switch depressed, adjust COIL CURRENT control clockwise

until meter indicates 20 to 25 KV on the black scale. Check that

COIL FLASHOVER indicator does not illuminate.

(6) Release PUSH TO TEST switch.

(7) Set COIL CURRENT control to extreme counterclockwise position.

(8) Set FUNCTION switch to OFF.

c. Coil Voltage Test (Delco-Remy 1115282).

See figure 2-5 and proceed as

follows:

(1)

Connect TEST LEAD with red boot to terminal lug on the end of the

wire to + connector.

(2)

Using adapter number 403BA034, connect the other TEST LEAD to the

connector.

Using adapter number 403BA033, connect COIL PICK-UP to coil secondary.

(3)

Be sure that adapter is firmly inserted into COIL PICK-UP and coil

secondary connector.

(4)

Connect the black lead attached to the COIL PICK-UP to the case of

the coil.

Set FUNCTION switch to COIL.

(5)

2-11