Remove six screws

TM 9-2920-257-30&P

NOTE

Scribe cover plate and front housing before removing cover plate

(10.) Remove six screws (16) and cover (17) from front housing (18).

NOTE

There are two connector assembly configurations, both procedures for removal

and repair are the same.

(11.) Remove connector assembly from front of hous ing.

Tag all leads.

See page 3-6 steps 3 and 4 for

procedure to remove connector assembly.

NOTE

Mark front housing and stator shell to insure proper alignment when generator is

reassembled

(12.) Remove nine flanged locknuts (10), front housing (18), with core and rotor attached from studs on stator

housing (12). Discard locknuts.

NOTE

Light taps with a soft-faced mallet will help in the separation of the parts.

Change 1 3-33