Press inside seal

TM 9-2920-257-30&P

(d) Press inside seal (10) into seal bore until it is flush with

face of anti-drive end housing (9).

(e) Turn anti-drive end housing (9) over in arbor press.

NOTE

O u t e r seal in anti-drive end housing is to be assembled so

that seal lips flare outward, away from rotor.

(f) Apply thin film of grease (item4, App B) to lips of

outer seal (11).

Place outer seal in position on the seal bore of

anti-drive end housing (9) with seal lips flaring outward, away from

rotor

(14).

See figure 3-8 for proper seal lip position.

(g) Press outer seal (11) into seal bore until it is flush

with face of anti-drive end housing (9).

(8) Install slideable bushing in anti-drive end housing ear

(a) Place anti-drive end housing (9) in arbor press so that

inner side of anti-drive end housing (side nearest rotor (14)) faces

up.

H o u s i n g ear must be supported.

(b) Press slideable bushing (13) into ear on anti-drive end

housing (9) until flush.

(9) Install anti-drive end housing on drive end housing

(a) Slide anti-drive end housing (9) on shaft of rotor (14).

(b) Push anti-drive end housing (9) tightly against stator (19)

m a k i n g sure that stator locator pin meshes with matching hole in

anti - drive

end housing.

3-23