 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2620-257-30&P
R e p l a c e unserviceable parts as
G e n e r a t o r Repair Procedure.
d.
required.
G e n e r a t o r Assembly Procedure.
e.
(1) Upon reassembly, all
parts
disturbed
during
disassembly,
e x c e p t brushes and brush holder, m u s t be coated with epoxy enamel (item
3, App B).
(2) Install inside seal to drive end housing assembly (fig. 3-1).
(a) Pack all rectifier leads down inside cavity in drive end
Place housing in arbor press with rectifiers
h o u s i n g assembly (21).
facing up.
CAUTION
Bearing will not seat properly if seal is not placed correctly.
Place seal on seal bore with seal lips flaring up.
(b) Place inside seal (22) in position on seal bore with seal lips
flaring
up . S e e f i g u r e 3 8 f o r p r o p e r s e a l l i p p o s i t i o n .
(c) Place ball bearing tool (fig. F-1) on top of inside seal (22)
Press in seal flush with bottom of bearing bore.
according to figure 3-9.
3-14
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals