CHAPTER 3. MAINTENANCE PROCEDURES - TM-9-2920-252-34-P0018

TM 9-2920-252-34&P

CHAPTER 3

MAINTENANCE PROCEDURES

SECTION I. GENERAL.

3-1. PURPOSE.

This chapter contains DS/GS applicable instructions for

general cleaning; disassembly; inspection, and repair of

(3) Personnel requirements.

component parts; assembly and leak testing.

(4) Equipment condition.

3-2. APPLICATION.

c. Procedure. Outlines the process for performing

All procedures in this chapter apply to both generator and

the task in step-by-step sequence.

both regulator configurations covered by this manual

except where identified as for Model 30B95-3-B or 30B95-

3-C generator.

3-4. ILLUSTRATIONS.

3-3. ORGANIZATION.

Each illustration used to describe a procedural step will be

located next to that step.

Each maintenance task described in this chapter will be

organized in the following manner:

a. Task. A description of the scope of the task.

3-5. REMOVAL AND INSTALLATION.

Refer to TM 9-2815-220-34 for instructions covering

b. Initial Setup. Lists the information you will need

removal and installation of the generator and regulator.

before starting the procedure, such as:

(1) Tool requirements.

3-6. GENERAL CLEANING

(2) Material and supplies requirements.

Solvent (Item 1, Appendix C)

Clean rag (Item 2, Appendix C)

Tape (Item 3, Appendix C)

Crocus cloth (Item 4, Appendix C)

Hard bristle brush (Item 10,

Goggles (Item 11, Appendix C)

Rubber gloves (Item 12, Appendix C)

3-1