Assembly of Drive Housing

C 1, TM 9-2920-242-35

a. Install new sleeve bearing (C) in drive housing

(5) Install 0.516-inch ID nonmetallic washer

(B). Drill oilhole and ream sleeve bearing bore to

(H, step 3) and rubber bushing (G) on

limits specified in wear limits (para 41e).

terminal stud of brush holder assembly (J).

(6) Install brush holder assembly (J) in com-

b. Saturate wick (H), and felt plug (D) with oil

mutator end plate (A), and secure with

(OE).

three No. 8 by -inch pan head screws

(M), lockwashers (L), and flat washers (K).

c. Apply sealer to expansion plug seat. Install

felt plug (D), gasket (F), and expansion plug (E).

(7) Install bushing (F, step 3), terminal stud

insulator (E), 0.520-inch ID flat washer

d. Install wick (H) and fill reservoir with oil (OE),

(D), -inch lockwasher (C), and -inch,

and install pipe plug (G).

0.310-inch thick hex nut (B).

e. Install rubber plugs (A) in housing (B).

56. Assembly of Drive Housing

57. Assembly of Starter Assembly

Refer to figure 52 and assemble drive housing as

follows:

Refer to paragraph 35 for assembly for starter

assembly except refer to figures 59 through 62 when

indexing the drive housing.

Figure 60. Pinion housing position--model LD-465-1 engine

Figure 59. Drive housing positionmodel ENDT-673 engine

application.