Assembly of Drive Clutch and Lever Housing

C 1, TM 9-2920-242-35

Figure 58. Assembling solenoid relay.

54. Assembly of Drive Clutch and Lever

55. Assembly of Commutator End Plate

Assembly

Housing

a. Assembly of Brush Holder Assembly. Refer to

a. Assembly of Drive Clutch. Refer to paragraph

32a and figures 29 and 30.

paragraph 33a and figure 11 and assemble the brush

holder assembly.

b. Assembly of Lever Housing. Refer to figure 54.

(1) Install sleeve bearing (H) in lever housing

b. Assembly of Commutator End Plate. Refer

(G). Ream sleeve bearing bore to limits

figure 53 and assemble the commutator end plate as

specified in wear limits (para 41c). Install

follows:

brake washer (J).

(1) Install a new bearing (N, step 4) in com-

(2) Saturate wick (A) and felt plug (C) with

mutator end plate (A). Drill oilhole and

oil (OE). Apply sealer to expansion plug

ream sleeve bearing bore to limits specified

seat. Install felt plug (C), gasket (D), and

in wear limits (para 41e).

expansion plug (E). Install wick (A) and

(2) Saturate wick (R, step 4) and felt plug (U)

fill reservoir with oil (OE) and install pipe

with oil (OE).

plug (B).

(3) Apply sealer to expansion plug seat. Install

(3) Apply sealer to oil seal counterbore and

install new oil seal (F).

felt plug (U, step 4), gasket (T), and ex-

pansion plug (S).

c. Assembly of Solenoid Plunger and Lever. Refer

to figure 31 and install solenoid plunger and lever in

(4) Install wick (R, step 4) and fill reservoir

lever housing.

with oil, and install pipe plug (Q).