Plunger and Lever Housing Assembly.

TM 9- 2920- 232- 34&P / TO 38X14- 2- 32

- -

ASSEMBLY OF THE STARTER - CONTINUED

0010 00

6. Plunger and Lever Housing Assembly.

a. Apply a light coat of grease to new preformed packings (1 and 2) and install at respective ends of lever shaft

(3).

b. Position shift lever (4), channel side inward, in lever housing (5) and install lever shaft (3), small end first,

through holes in lever and housing.

Install retaining ring (6) to secure lever shaft (3) in housing (5).

d. Install oil seal (7) at inner end of armature bore in lever housing (5).

e. Install new lubricated wick (8) and oil reservoir cap (9) into lever housing (5). Tap in flush to housing using a

wood block and hammer. Install red rubber plug (10) into lever housing.

0010 00- 9