Disassembly Lever Housing Assembly.

TM 9- 2920- 232- 34&P / TO 38X14- 2- 32

- -

DISASSEMBLY OF THE STARTER ASSEMBLY - CONTINUED

0008 00

6. Disassembly Lever Housing Assembly.

a. Using retaining ring pliers, remove retaining ring (1) from end of lever shaft (2).

b. Push on end of lever shaft (2) to start shaft removal from housing (3).

Hold large end of lever shaft (4) and pull shaft from housing (3).

d. Remove shift lever (5) from housing (3).

e. Inspect shift lever for cracks or distortion. Replace if defective.

Check shaft bore in shift lever. Replace lever if bore does not conform to 0.508 to 0.512 inch.

g. Inspect shift lever clutch contact surfaces for rough spots, scratches, and nicks. Replace if defective.

h. Remove two preformed packings (6) from lever shaft (4). Discard packings.

Inspect lever shaft for rough spots, scratches, and nicks. Replace if defective.

Check diameter of shaft. Replace shaft if it does not conform to 0.4980 to 0.5000 inch. The fit of the shaft in

shift lever shall be 0.008 to 0.014 inch loose fit.

0008 00- 14