Remove six hex head screws

TM 9- 2920- 232- 34&P / TO 38X14- 2- 32

- -

DISASSEMBLY OF THE STARTER ASSEMBLY - CONTINUED

0008 00

p. Remove six hex head screws (20), which attach brush leads to holders (21).

NOTE

The 12--brush starters will have 9 pan head screws to remove. Three of these screws were

removed to disconnect field leads.

If brush is serviceable and will be re--installed at assembly, mark brush and holder so that

brush will be in original location.

q. Using brush spring lifter, raise spring and slide brush (22) down through holder (21).

Remove nut (23), lock washer (24), and flat washer (25). Discard lock washer.

Remove three screws (26). Using a soft plastic hammer, tap to remove brush holder assembly (27) from end

plate assembly (12).

Remove two washers (28) and insulator (29).

u. Remove terminal stud insulator (30) and insulating bushing (31) from end plate (12).

Drill a 5/32 inch hole near center of exposed surface of oil reservoir cap (32) and thread a thread forming

tapping screw (33) into this hole to use as a puller. Remove cap (32) and wick (34) and discard.

0008 00- 6