 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
STARTER MOTOR END PLAY ADJUSTMENT (Sheet 2 of 2)
ADJUSTMENT:
1.
CONNECT TEST SETUP.
a. Put cable (1) on positive terminal (2) of
power supply (3). Put other end of cable
(1) on switch terminal 1 (4) of switch
assembly (5).
b. Put cable (6) on negative terminal (7) of
power supply (3). Put other end of cable
(6) on terminal stud (8).
c. Remove plug (9) from solenoid cap (10).
d. Turn power supply switch (11) to ON. Set
switch assembly (12) of test cable to ON.
2.
PUT TIMING GAGE (13) BETWEEN FACE
OF PINION GEAR (14) AND THRUST
WASHER (15) WHILE OPERATING
SWITCH (12). IF GAGE (13) WILL NOT FIT
OR IS LOOSE, DO STEP 3.
TURN PLUNGER (16) THROUGH ACCESS
3.
HOLE (17) OF CAP (10) IN OR OUT AS
REQUIRED UNTIL GAGE (13) FITS
BETWEEN GEAR (14) AND WASHER (15).
SET SWITCH (11) TO OFF. INSTALL NEW
4.
PLUG (9) IN CAP (10).
5.
REMOVE CABLE (6) FROM POWER
SUPPLY (3) AND MOTOR (18).
TEST STARTER MOTOR (PAGE 9-43).
6.
LUBRICATE STARTER MOTOR
7.
End of Task
9-63/(9-64 blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals