 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
STARTER MOTOR REPAIR (Sheet 8 of 11)
15. REMOVE TWO CAMS (1). PLAIN SEAL (2).
AND BUSHING (3).
a. Take cams (1) off arm and link (4).
b. Lift seal (2) from housing (5).
c. Remove bushing (3) from housing (5).
16. INSPECT PARTS FOR DAMAGE. REPLACE
AS REQUIRED.
17. INSTALL NEW BUSHING (3) AND NEW
SEAL (2).
a. Install bushing (3) in housing (5),
b. Install seal (2)
in housing (5) with rubber
side of seal (2)
facing toward bushing (3).
Use l-inch end
of driver shaft to seat
seal (2) against
bushing (3).
18. INSTALL TWO CAMS (1), ARM AND LINK
(4), SHAFT (6), NEW PACKING (7), NEW
WASHER (8), NEW SEAL (9), AND
DRIVE (10),
a. Apply a light coat of oil on cams (1). Put
cams (1) on arm and link (4). Put arm
and link (4) in housing (5).
b. Put packing (7) on shaft (6). Install shaft
(6) in housing port (11) and arm and link
pivot hole (12).
c. Put washer (13) in shaft slot (14) and
install screw (15).
d. Install seal (9) and washer (8) in housing
(5). Slide drive (10) between cams (1).
Go on to Sheet 9
9-58
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals