 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
STARTER MOTOR REPAIR (Sheet 11 of 12)
5. INSTALL DRIVE HOUSING (1) AND NEW
GASKET (2) ON HOUSING (3). INSTALL
AND TORQUE SIX SCREWS (4, 5)
BETWEEN 155-200 LB-IN (18-23 Nm).
a. Put gasket (2) in seat (6) on housing (3).
b. Line up scribe mark (7) at plug (8) on
housing (1) with scribe mark (9) on
housing (3).
c. Install short screw (4) in housing (1).
Install five screws (5) in housing (1).
d. Torque screws (4, 5) between 155-200 lb-in
(18-23 Nm).
6. INSTALL NEW PACKING (10) AND
POSITION END BELL (11) ON MOTOR (12).
a. Put packing (10) in groove (13) of end
bell (11).
b. Pull armature (14) out of motor (12) until
bar risers (15) stick outside of motor (12)
as far as possible.
c. Put end bell (11) in motor (12) until first
four brushes (16) are against bar
risers (15).
d. Push brushes (16) all the way in holders
(17) until each brush (16) is over bar
riser (15).
Go on to Sheet 12
9-38
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals