 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
STARTER MOTOR REPAIR (Sheet 10 of 12)
28. INSTALL FOUR NEW BRUSHES (1) IN
HOLDERS (2).
a. Put brushes (1) in holders (2) from center
of brush holder assembly (3).
NOTE
Two screws (4) are not installed until motor is
assembled.
b. Install four screws (5) holding leads (6).
Remove end bell (7) from vise.
ASSEMBLY:
1. INSTALL WASHER (8) ON SHAFT (9) AND
INSTALL ARMATURE (10) IN FRAME (11).
2. INSTALL WASHER (12), RACES (13, 14),
BEARING (15), NEW PACKING (16), AND
HOUSING (17) ON FRAME (11).
a. Fill grease cavity (18) with grease.
NOTE
Inner bearing race (13) is thinner than outer
bearing race (14).
b. Put washer (12), race (13), bearing (15),
and race (14) on shaft (19).
c. Put packing (16) on housing (17). Slip
housing (17) on shaft (19) and guide
plunger (20) in body (21).
d. Rock housing (17) gently to make contact
with frame (11) and body (21).
SECURE HOUSING (17) TO FRAME (11)
3
WITH FIVE SCREWS (22) AND NEW
LOCKWASHERS (23).
4,
INSTALL COLLAR (24) AND NEW PIN (25)
ON SHAFT (19). TIGHTEN CLAMP (26).
Go on to Sheet 11
9-37
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals