 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
STARTER MOTOR TEST (Sheet 2 of 3)
2. REMOVE TWO PLUGS (1) AND
GASKETS (2). INSPECT PLUGS (1) FOR
DAMAGE. REPLACE AS REQUIRED.
3. TEST ARMATURE CONTINUITY.
a. Set multimeter to RX1 scale and check
continuity between two brush terminals
(3). If multimeter reads 10 ohms or more,
replace motor (4).
b. Set multimeter to RX10,000 scale and
check continuity between each terminal
(3) and motor housing (5). If multimeter
reads anything except infinity, replace
motor (4).
4. TEST SOLENOID RESISTANCE.
a. Set multimeter to RX1 scale and check
resistance between switch terminal (6)
and B terminal (7). If multimeter reads
10 ohms or less, go to step b. If
multimeter reads more than 10 ohms,
replace starter motor solenoid switch
b. Set multimeter to RX10,000 scale and
check resistance between switch terminal
(6) and case (8). Check resistance between
M terminal (9) and case (8). Check
resistance between B terminal (7) and
case (8). If multimeter reads anything
except infinity for any of three checks,
replace starter motor solenoid switch
Go on to Sheet 3
9-23
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals