 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
STARTER MOTOR REPAIR (sheet 10 Of 13)
27. INSPECT HOLDER (1) FOR DAMAGE.
REPLACE AS REQUIRED.
28. INSTALL NEW WASHER (2), NEW
PACKING (3), NEW SPACER (4), AND
CONNECT END BELL (5) AND
HOLDER (1).
a. Put washer (2) and packing (3) on stud
(6). Put spacer (4) in end bell (5).
b. Put sealing compound on back of holder
(1). Put holder (1) on end bell (5).
29. ALINE HOLDER (1) WITH END BELL (5).
INSTALL THREE NEW SCREWS (7) AND
WASHERS (8).
30. INSTALL NUT (9), NEW LOCKWASHER
(10), WASHER (11), AND NEW
INSULATOR (12) ON STUD (6). SKIP
STEPS 31 THRU 34.
31. PULL SPACER (4), PACKING (3), AND
WASHER (2) FROM STUD (6). REPLACE
HOLDER (1).
32. INSTALL NEW WASHER (2), NEW
PACKING (3), NEW SPACER (4), AND
CONNECT END BELL (5) WITH NEW
HOLDER (1).
a. Put washer (3), packing (2), and spacer (4)
on stud (6) of holder (1).
b. Put sealer on back of holder (1). Put
holder (1) on end bell (5).
33. ALINE HOLDER (1) WITH END BELL (5).
INSTALL THREE SCREWS (7) AND
WASHERS (8).
34. INSTALL NUT (9), NEW LOCKWASHER
(10), AND NEW INSULATOR (12) ON
STUD (6).
35. INSTALL EIGHT NEW SPRINGS (13) AND
NEW BRUSHES (14) ON END BELL (5).
a. Put springs (13) on four holders (15). Put
brushes (14) in holders (16) from center of
holder (1).
NOTE
Two screws (17) are not installed until motor is
assembled.
b. Install six screws (18) that hold leads
(19). Remove end bell (5) from vise.
Go on to Sheet 11
9-15
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals