 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
STARTER MOTOR REPAIR (Sheet 9 of 13)
21. REMOVE EIGHT BRUSHES (1) AND
HELICAL SPRINGS (2) FROM END
BELL (3).
a. Put end bell (3) in vise. Remove six
screws (4) from six brush leads (5)
b. Pull brushes (1) out of eight brush
holders (6). Remove springs (2) from four
spring holders (7).
22, SET MULTIMETER TO RX1 SCALE.
CHECK CONTINUITY BETWEEN STUD (8)
AND TWO GROUND BRUSH HOLDERS (9).
IF CONTINUITY IS NOT FOUND FOR
EITHER HOLDER (9), DO STEP 24 AND
THEN GO TO STEP 31.
23, SET MULTIMETER TO RX1 SCALE.
CHECK CONTINUITY BETWEEN STUD (8)
AND TWO INSULATED BRUSH HOLDERS
(10). IF A CONTINUITY IS FOUND, GO TO
STEP 27.
24, SEPARATE HOLDER ASSEMBLY (11) AND
END BELL (3).
a. Remove nut (12), lockwasher (13),
washer (14), and insulator (15) from stud
(8).
b. Remove three screws (16) and washers
(17) from holder (11). Tap stud (8) until
holder (11) separates from end bell (3).
25. PULL SLEEVE SPACER (18) FROM END
BELL (3). PULL PREFORMED PACKING
(19) AND WASHER (20) FROM STUD (8).
26. INSPECT
END BELL (3) FOR CRACKS OR
BREAKS.
INSPECT BUSHING (21) FOR
CRACKS,
BREAKS, OF SCORE MARKS.
REPLACE
AS REQUIRED.
Go on to Sheet 10
9-14
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals