 |
|||
|
|
|||
|
Page Title:
FUSION WELD REPAIR CRACKED FILLET WELD AREAS |
|
||
| ||||||||||
|
|
 TM 9-2835-255-34
LUBRICATING OIL TANK REPAIR (Sheet 6 of 7)
3. FUSION WELD REPAIR CRACKED FILLET WELD
AREAS (1) AND BROKEN OR CRACKED MOUNTING
PLATE (2) AND BRACKET MATERIAL OF MOUNTING
SUPPORT (3) AND LOWER BRACKET (4).
a.
Repair cracked fillet weld areas (1) by continu-
ous fusion welding.
b.
Repair cracks in parent metal of mounting
support (3), lower bracket (4) and mounting
plate (2) by fusion welding edges of mounting
support (3) and lower bracket (4) to mounting
plate (2).
WARNING
4. CLEAN ALL EXTERIOR WELD REPAIR AREAS
USING WIRE BRUSH AND CLEANING SOLVENT
5. CHECK REPAIRED AREA(S) FOR CRACKS AND
BAD WELDS. REPAIR AS REQUIRED. PERFORM DYE
PENETRANT INSPECTION IF APPLICABLE.
6. USING SPANNER WRENCH (6), REMOVE DAM-
AGED BUSHING (5). INSTALL AND SECURELY
TIGHTEN NEW BUSHING (5) USING SPANNER
WRENCH (6).
Go on to Sheet 7
8-9
Change 6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals