Unscrew and remove handle

TM9-2835-255-34

ACCESSORY GEARBOX CLEANING AND REPAIR (Sheet 16 of 40)

Hold handle (1) and turn handle (2) clockwise

until bearing (3) is pulled off gearshaft (4).

Set puller (5) and bearing (3) onto clean work

surface.

Unscrew and remove handle (1) and body

half (6). Remove bearing (3) from puller (5).

Put body half (6) on puller (5) and screw in

handle (1). Stow assembled puller (5).

NOTE

If bearings were removed because gear-

shaft was bad, skip step e. and replace

gearshaft.

Check for scoring at two bearing journals (7).

Measure diameter of journals (7) with caliper.

Check that diameters are 1.5747 to 1.5751

inch (39.997 to 40.007 mm). If bad, replace

gearshaft. If good, set aside for later assem-

bly.

Go on to Sheet 17

7-61

Change 6