ATTACH 30 INCH NON-ELECTRICAL PULL THROUGH WIRE

TM 9-2835-255-34

DIRECT LINEAR VALVE REPLACEMENT (Sheet 3 of 6)

ATTACH 30 INCH NON-ELECTRICA.L

PULL THROUGH WIRE (1), WITH KNOT

AROUND EXPOSED PINS (2,3), TO LOOSE

WIRES. COVER KNOT WITH TAPE TO

FORM SMOOTH SURFACE.

NOTE

Do not pull non-electrical wire (1) out of electro-

mechanical fuel system. Keep wire routed for

installation.

THROUGH THE ACCESS CAVITY (4),

PULL THE DIRECT LINEAR VALVE WIRE

(RED AND BLUE IN CLEAR SLEEVE) (.5)

OUT OF THE ELECTROMECHANICAL

FUEL SYSTEM (6).

REMOVE TAPE AND DISCONNECT NON-

ELECTRICAL WIRE FROM PINS.

().

REMOVE DIRECT LINEAR VALVE (7)

FROM ELECTROMECHANICAL FUEL

SYSTEM (6).

NOTE

if wires other than the wires you work on break or

come out of the housing, assemble eleclro-

mechanicnl fuel system using old parts and replace

electromechanical fuel system.

11. [NSPECT WASHERS FOR DAMAGE. RE-

PLACE AS REQUIRED.

INSTALLATION:

LUBRICATE NEW PREFORMED PACK-

INGS (8 AND 9) WITH SHORTENING

COMPOUND AND SLIDE PACKING (9) UP

THE NEW DIRECT LINEAR VALVE INTO

GROOVE (10). PLACE PACK{NGS (8) IN

GROOVES (11).

Go on to Sheet 4

7-42 Change 4