INSTALLATION - TM-9-2835-255-340651

TM 9-2835-255-34

POWER TURBINE STATOR (PTS POWER TRANSFORMER REPLACEMENT (Sheet 3 of 5)

NOTE

Do not pull nonelectrical wire (1) out of eleclro-

mechanical fuel system. Keep wire routed for

installation.

PULL THE POWER TRANSFORMER WIRE

(GREEN) (2) OUT OF THE

ELECTROMECHANICAL FUEL SYSTEM

(3) THROUGH THE ACCESS CAVITY {4).

REMOVE TAPE AND DISCONNECT

NONELECTRICAL WIRE FROM PINS.

REMOVE POWER TRANSFORMER (5)

AND GASKET (6).

NOTE

If wires other than the wires you work on break or

come out of the housing, assemble electro-

mechanical fuel system using old part and replace

electromechanical fuel system.

l0. INSPECT WASHERS FOR DAMAGE.

REPLACE AS REQULRED.

INSTALLATION:

[NSTALL NEW GASKET (6) AND NEW

POWER TRANSFORMER (5) ONTO

ELECTROMECHANICAL FUEL SYSTEM

(3).

NOTE

Do not put in new screws and washers in power

transformer at this time.

ATTACH NONELECTRICAL WIRE (1) TO

PINS AND ROUTE THROUGH ELECTRO-

MECHANICAL FUEL SYSTEM (3).

At access cavity (4), attach non- electrical

wire (1 ) to pins with knot. Cover with tape

to form smooth surface.

b. Route power transformer wire (3) carefully

out through connector elbow (7).

c. Remove tape and nonelectrical wire from

pins.

Go on to Sheet 4

7-32 Change 4