 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
SCREW THREAD INSERT REPLACEMENT (MACHINE THREAD PLUG) (Sheet 2 of 3)
333
COAT TAP (1) WITH SHORTENING COM-
POUND TO CAPTURE ANY CHIPS.
CHASE THREADS WITH TAP (1) TO
REMOVE NICKS AND BURRS. CLEAN
OUT HOLE (2) USING WIPING RAG.
4.
USING FLASHLIGHT, INSPECT HOLE (2)
FOR MISSING OR CROSSED THREADS. IF
THREADS ARE MISSING OR CROSSED,
REPLACE ACCESSORY GEARBOX (3)
(PAGE 7-21 ).
INSTALLATION:
INSTALL NEW INSERT (4) INTO ACCES-
11.
SORY GEARBOX (3) USING SCREW
THREAD INSERT TOOL KIT.
a.
Install insert (4) onto end of wrench (5)
until tang (6) is seated against tip of
wrench (5).
b..
Install wrench (5) with insert (4) attached
into mandrel (7) until one thread of insert
(4) is one thead past tip of mandrel (7).
c.
Place wrench (5), mandrel (7), with insert
(4) attached, into hole (2). Holding
mandrel (7), turn wrench (5) clockwise
until top (8) of insert (4) is one and
on-half turns below surface of hole (2).
d.
Remove wrench (5) and mandrel (7).
Go on to Sheet 3
7-26 Change 4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals