APPLY ANTISEIZE COMPOUND TO FOUR INNER MOUNTING BOLTS

TM 9-2835-255-34

GAS TURBINE POWER UNIT REPLACEMENT (Sheet 24 of 30)

NOTE

If remote control lever (1) moves freely

when rotated by hand, go to CAUTION

before step 13.

If remote control lever (1) cannot be ro-

tated freely by hand, repeat step 12.a.

through y. If this is the third attempt to

eliminate binding, assemble rear engine

module with original parts and replace.

CAUTION

Retrieve any inner mounting bolts (2) that

are dropped or fall out during assembly.

Loose hardware will cause damage to

engine during operation.

13. APPLY ANTISEIZE COMPOUND TO FOUR INNER

MOUNTING BOLTS (2), INSTALL AND TIGHTEN

SECURELY SAFETY WIRE BOLTS (2).

14. SAFETY WIRE TURNBUCKLE ROD BEARING

ASSEMBLY RETAINING BOLT (3) TO SPUR GEAR-

SHAFT (4).

15. REMOVE FOUR TEMPORARY BOLTS (5) AND

SPACERS (6).

NOTE

Verify that rigging pin (7) has been re-

moved and turbine gearbox housing inner

mounting bolts (2) are safety wired.

Go on to Sheet 25

6-85

Change 6