ROTATE REMOTE CONTROL LEVER - TM-9-2835-255-340584

TM 9-2835-255-34

GAS TURBINE POWER UNIT REPLACEMENT (Sheet 10 of 30)

20. ROTATE REMOTE CONTROL LEVER (1) UNTIL

RIGGING PIN (2) CAN BE INSERTED THROUGH

HOLE IN SPUR GEAR (3) AND INTO ALIGNMENT

HOLE IN SHROUD (4). INSERT RIGGING PIN (2).

21. CUT SAFETY WIRE AND REMOVE FOUR BOLTS

(5).

22. LOOSEN SELF-LOCKING NUT (6) TO WITHIN

ONE THREAD OF END OF SHAFT (7). DO NOT

REMOVE NUT (6).

23. PUSH DOWN ON SELF-LOCKING NUT (6)

UNTIL SHAFT (7) IS SEATED.

24. CUT LOCKWIRE, REMOVE BOLT (8) AND SWING

TURNBUCKLE ROD BEARING ASSEMBLY (9) AWAY

FROM SPUR GEARSHAFT (10). RETAIN BOLT (8)

FOR FURTHER USE.

CAUTION

Do not adjust turnbuckle rod bearing

assembly (9). Alignment of vanes with

turbine gearbox housing assembly is

preset at the factory and must not be

disturbed. Damage to internal parts may

result which may not be readily apparent

during visual inspection.

Go on to Sheet 11

6-71

Change 6