REMOVE NO. 2 BEARING SEAL HOUSING

TM 9-2835-255-34

NO. 2 AND 3 BEARING SEAL/PACKING RETAINER REPLACEMENT (INCLUDING INTERSHAFT SEAL)

(Sheet 18 of 49)

16. REMOVE NO. 2 BEARING SEAL HOUSING (1)

AND PREFORMED PACKING (2) FROM INTERMEDI-

ATE MECHANICAL HOUSING (3).

CAUTION

Do not allow debris or foreign objects to

fall into high pressure compressor area.

Damage to components may result. Cover

opening of high pressure compressor with

wiping rags as required.

Cut safety wire and remove four bolts (4) se-

curing No. 2 bearing seal housing (1) to inter-

mediate housing (3).

Using three of bolts (4), removed in step a., as

jacking screws, install bolts (4) into three

threaded holes (5) of No. 2 bearing seal hous-

ing.

Tighten bolts (4) evenly opposite each other

until No. 2 bearing seal housing (1) is away

from intermediate housing (3). Remove No. 2

bearing seal housing (1).

Remove and discard preformed packing (2)

from No. 2 bearing seal housing (1).

17. REMOVE OIL TRANSFER SLEEVE (6). REMOVE

AND DISCARD TWO PREFORMED PACKINGS (7)

FROM OIL TRANSFER SLEEVE (6).

Go on to Sheet 19

5-92

Change 6