 |
|||
|
|
|||
|
Page Title:
PERFORM A SLIP FIT CHECK OF NO. 2 BEARING HOUSING |
|
||
| ||||||||||
|
|
 TM 9-2835-255-34
NO. 2 AND 3 BEARING SEAL/PACKING RETAINER REPLACEMENT (INCLUDING INTERSHAFT SEAL)
(Sheet 16 of 49)
NOTE
Performing the slip fit check of step 14
may not be necessary when using original
hardware. This slip fit check is required
when new or different hardware is used.
14. PERFORM A SLIP FIT CHECK OF NO. 2 BEAR-
ING HOUSING (1) INTO NO. 2 BEARING SEAL
HOUSING (2).
CAUTION
Do not allow debris or foreign objects to
fall into high pressure compressor area.
Damage to components may result. Cover
opening of high pressure compressor with
wiping rags as required.
Insert No. 2 bearing housing (1) into No. 2
a.
bearing seal housing (2), slip lugs into slots
and seat No. 2 bearing housing (1) onto No. 2
bearing seal housing. Check for binding.
Lift No. 2 bearing housing (1),turn
b.
approximately 60 degrees clockwise and re-
peat step a.
Repeat step b. five times, turning No. 2 bear-
c.
ing housing (1) 60 degrees clockwise each
time.
NOTE
If any binding is felt, forward engine mod-
ule is not repairable at DS level of mainte-
nance. Reassemble forward engine mod-
ule with original hardware and replace
forward engine module (Page 5-13).
CAUTION
LE5562
Do not handle bearing or bearing races
with bare hands. Damage to parts may
result. Use clean cotton gloves.
Go on to Sheet 17
Change 6
5-90
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals