 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
NO. 1 BEARING SEAL/PACKING RETAINER REPLACEMENT (Sheet 19 of 21)
CAUTION
Make sure packing retainer (1) does not
shear or crack while deforming. If packing
retainer (1) shears or cracks, replace.
22. DEFORM PACKING RETAINER (1) INTO PLAIN
ROUND NUT (2) AT TWO PLACES, 160 DEGREES
APART VISUALLY INSPECT DEFORMED PACKING
RETAINER (1) FOR SHEARING OR CRACKS.
23. INSTALL PREDETERMINED RING SPACER (3)
AND BEARING HOUSING (4) ONTO INLET HOUSING
(5).
a.
Install predetermined ring spacer (3) onto
bearing housing (4) and align all holes.
NOTE
Low pressure compressor speed pickup
hole (6) in bearing housing (4) is identified
for reference only.
b.
Align low pressure compressor speed pickup
hole (6) in bearing housing (4) with 10 o'clock
strut (7) on inlet housing (5) and install bear-
ing housing (4) onto inlet housing (5). Secure
with six bolts (8) tightened between 40-45
lb-in (4.52-5.08 Nm) torque in a staggered
sequence.
LE5518
Compressor blades are sharp and can cut
you. Be careful not to pinch fingers be-
tween blades and vanes when turning
compressor.
Go on to Sheet 20
Change 6
5-72
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals