POSITION INLET HOUSING

TM 9-2835-255-34

NO. 1 BEARING SEAL/PACKING RETAINER REPLACEMENT (Sheet 11 of 21)

2. POSITION INLET HOUSING (1) NOSE DOWN ON

WORK SURFACE AND INSTALL FOUR BOLTS (2).

Apply antiseize compound to four bolts (2).

Install and torque bolts (2) evenly between

40-45 lb-in (0.45-0.51 Nm).

Safety wire must be routed around outside

of spring pin (3) to prevent contact with

rotor.

Using double twist method, install new safety

wire to two bolts (2) at 8 o'clock and 10

o'clock positions. install new safety wire to two

bolts (2) at 2 o'clock and 4 o'clock positions.

Run safety wire around outside of interceding

spring pin (3).

3. APPLY SHORTENING COMPOUND TO NEW

PREFORMED PACKING (4) AND INSTALL INTO

GROOVE (5) AT REAR OF INLET HOUSING (1).

Go on to Sheet 12

Change 6

5-64