Remove four self-locking nuts

TM 9-2835-255-34

NO. 1 BEARING SEAL/PACKING RETAINER REPLACEMENT (Sheet 7 of 21)

Remove four self-locking nuts (1) and four

cap screws (2).

Ensure inlet guide vane (IGV) bellcrank (3) is

in full closed position.

NOTE

Inlet housing (4) is heavy and may require

two persons to lift. Damage to compo-

nents or injury to personnel may result if

dropped or mishandled. Use firm grip

while lifting.

CAUTION

Use care not to bump low pressure com-

pressor shaft (5) when removing inlet

housing (4). Damage to shaft may result.

Firmly grasp inlet housing (4) with both hands .

and pull straight off low pressure rotor and

housing assembly (6). Place inlet housing

(4) nose down on clean work surface.

Remove and discard preformed packing (7)

from inlet housing (4).

Go on to Sheet 8

Change 6

5-60