 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
FORWARD ENGINE MODULE (GEARBOX MODULE ATTACHED) REMOVAL
AND INSTALLATION (Sheet 4 of 7)
WARNING
6. REMOVE MODULE (1) FROM STAND (2).
a. Remove sling (3) from chain hoist hook
(4). Install sling (3) on hoist hook (5).
b. Move module (1) away from stand (2) and
set on three wood blocks (6).
NOTE
If rear module (7) is being replaced, go to
installation step 1.
7. REPLACE SEAL RINGS AND EXPANDER
SPRINGS (PAGE 6-33).
INSTALLATION:
1. INSTALL MODULE (1) ON STAND (2).
a. Install sling (3) on chain hoist hook (4).
b. Operate hoist until there is tension on
chain hoist hook (4).
c. Lower module (1) until sling (8) is slack.
Remove sling hook (9) from shackle (10)
on sling (3).
CAUTION
Do not lean on, or hang anything on shaft (11).
Damage to bearing seal or air seal may result.
2. REMOVE TRANSFER SLING (8).
a. Remove pin (12) from shackle (13).
Remove shackle (13) from ring (14) and
install on first chain link (15). Install
pin (12).
b. Remove and stow sling (8).
Go on to Sheet 5
5-28
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals