Installation-continued - TM-9-2815-224-34-P0440

TM 9-2815-224-34&P

Engine Governor Maintenance Instructions (Cont)

Install plate (9) with screw (10) and lockwasher (11).

(6)

Install nut (11.1) and washer (11.2) onto solenoid (12).

(6.1)

Install solenoid (12) with actuating screw (13) in hole of bracket (4).

(7)

Aline matchmarks and install stop lever (5).

(7.1)

Tighten screw (8).

(7.2)

Install plate (9) with screw (10) and lockwasher (11).

(7.3)

Position solenoid (12) on plate (9).

(7.4)

Install cable bracket (13.1) with two screws (13.2), washers (13.3), lockwashers (13.4), and

(7.5)

nuts (13.5).

(7.6) Install shutdown cable (1) on cable bracket (13.1) and tighten two nuts (13.6).

(7.7) InstaIl shutdown link (13.7) on shutdown cable (1) and locknut (13.8). Do not tighten locknut.

(7.8) Install bracket (4) on actuating screw (13).

(7.9) Install screw (13.9) in shutdown link (13.7) with two washers (13.10) and locknut (13 11)

Tighten locknut to provide 0.03 in. (0.76 mm) clearance above and below shutdown link (`13 ).

(7.10) InstaIl stop lever (5) and bracket (4) on screw (13.9) with locknut (13.12). Tighten locknut to

provide 0.03 in. (0.76 mm) clearance above and below bracket (4).

(7.) Adjust locknuts (13.8) until shutdown link (13.7) has approximately 0.38 in. (9.65 mm) free

play in slot before shutdown link contacts screw (13.9). Tighten locknuts.

(8) Install washer (14), two nuts (15), wires (16), and ground wire (17).

15-40

Change 2