Assembly-continued - TM-9-2815-224-34-P0404

TM 9-2815-224-34&P

Engine Governor Maintenance Instructions (Cont)

15-3. GOVERNOR REPAIR (CONT).

(21) Lubricate inside lower bearing (28) with grease, and

lubricate outside with lubricating oil.

(22) Start lower bearing (28) closed side up into governor

housing (2) over shaft (21).

(23) Press lower bearing (28) on shaft (21) until it seats on

shoulder in governor housing (2).

WARNING

Adhesives, solvents, and sealing compounds can burn

easily, can give off harmful vapors, and are harmful to

skin and clothing. To avoid injury or death, keep away

from open fire and use in well-ventilated area. If

adhesive, solvent, or sealing compound gets on skin or

clothing, wash immediately with soap and water.

(24) Apply small amount of pipe thread sealing compound

to edge of expansion plug (29).

(25) Install expansion plug (29), curved side up, in

governor housing (2).

(26) Tap center of expansion plug (29) to seal.

(27) Install pin (30) into link (31).

(28) Connect link (31) and (32).

(29) Install two retainer clips (33) and

springs (34).

(30) Install pin (35).

(31) Install differential lever (36),

washer (37), and spring clip (38)

on operating shaft lever (17).

(32) Install short end of connecting

link (31), washer (39), and spring

clip (40) on operating shaft

lever (17).

15-12