 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2815-224-34&P
Blower Maintenance Instructions (Cont)
Deleted.
(14)
CAUTION
Blower housing and rear end plate mating
surfaces must be perfectly flat and smooth or
parts will not seal.
Allow Teflon sealant to dry to the touch before
installing rear end plate. Teflon sealant must
not protrude into blower housing or damage to
blower may result.
Teflon sealant must not prevent rear end plate
from laying flat against the blower housing or
damage to blower may result.
Apply a thin, even coating of Teflon sealant over entire end surface of rear end plate side of
(15)
blower housing (7). Wipe off any excess sealant from housing bores.
(16) Deleted.
(17) Deleted.
(17.2) Install two pilot tools (4.6) on rotor shafts (4).
NOTE
Plastic seal protectors will be pushed out of seals when rear end plate is installed.
Position rear end plate (10) and aline dowel pins (11) to holes in blower housing (7).
(18)
Tap rear end plate (10) into blower housing (7).
(19)
Install and tighten two screws (12) to 10 lb-ft (14 Nm).
(20)
Apply lubricating oil to two ball
(21)
bearings (13).
Install two ball bearings (13) numbered
(22)
end up, in rear end plate (10) with
bearing installer.
Change 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals