Installation. - TM-9-2815-224-34-P0119

TM 9-2815-224-34&P

Crankshaft Maintenance Instructions (Cont)

b. Installation.

NOTE

If crankshaft has split pin, do step (1) then step (3). If no split pin, go to step (2).

Install split pin (1).

(1)

WARNING

Adhesives, solvents, and sealing compounds can burn easily, can give off harmful

vapors, and are harmful to skin and clothing. To avoid injury or death, keep away

from open fire and use in well-ventilated area. If adhesive, solvent, or sealing

compound gets on skin or clothing, wash immediately with soap and water.

NOTE

There are two models of crankshafts. Model B crankshaft, used in engines with

Serial No. 8VF-098597 and later, has a different machined diameter for the oil

pump drive gear. The oil pump drive gear has not changed but must be pressed on,

without adhesive, for Model B crankshaft. Skip step (2) for Model B crankshafts.

Apply retaining compound to crankshaft (2).

(2)

Install woodruff key (3).

(3)

Install spacer (4), finished side facing away from engine (5).

(4)

Install oil pump drive gear (6), flat side of hub facing away from engine (5) and beveled side of

(5)

hub facing towards engine.

Follow-on Maintenance. Install crankshaft cover and front oil seal (para 4-6).

END OF TASK

Change

4-9