 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2815-224-34&P
Cylinder Head Maintenance Instructions (Cont)
b. Installation.
NOTE
q Injector tube must be reamed before injectors can be installed.
All injector tubes are installed the same way.
q
(1) Clean dirt from injectors tube (1) and hole.
(2) Install preformed packing (2) into cylinder head counterbore (3).
(3) Tap injector tube (1) into injector tube hole using installer until bottom rim of installer is flush
with cylinder head (4).
(4) Set cylinder head (4) upside
down on two wood blocks.
(5) Seat injector tube (1) using
upsetting die. Tighten to
30 lb-ft (40 Nm) and
remove die.
3-55
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals